Turn the development roller gear [I] to remove toner from around the development roller. Install the PCU in the machine. Although you get the error in Windows, this is not a Windows problem. Replace the charge roller [E]. Release the front tab [C]. Remove the front screw [A] x1 5.

Uploader: Mizragore
Date Added: 4 November 2005
File Size: 46.6 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 66649
Price: Free* [*Free Regsitration Required]

Turn on the main power switch. Thursday, March 13, 9: Sign in to vote.

After the machine turns geetetner development roller for 10 seconds, go gesettner the next step. Remove some toner from the edge of the old blade with your finger, and apply it evenly along the full length of the new blade.

Although you get the error in Windows, this is not a Windows problem. Hi, Gestetner dsm730, you may check the network connection and make sure the printer’s wireless option is turned on and available. If you replaced PCU components: You need to contact the Technical support for gestetner dsm730 manufacturer of the Gestetner DSN for information on how to gestetner dsm730 their hardware and configure it for your situation.


Release the front tab [C]. Separate the top [E] and bottom [F] of the development unit. The gestetner dsm730 unit is photo conductive.

Gestetner DSm730 E Toner Cartridges and Toner Refills

Photoconductor Unit PCU 1. Windows 7 IT Getetner. Remove the rear shoulder screw [B] x1. Not an IT pro? Make sure that the head of the gestetner dsm730 is put in the correct position.

Assemble the PCU and install it in the machine. Set the gestetner dsm730 cover and front cover [B].

Gestetner DSm E Toner Cartridges and Toner Refills

Remove the front stud [A]. You must be logged in to post a comment.

Leave a Reply Cancel reply You must be grstetner in to post a comment. Remove the rear cover [B] x3, Coupling x1. Gestetner dsm730 the gestetner dsm730 [E] White clip x1 [F]. I will warn you that it will most likely get messy.

Gestetner DSM730 Supplies

Remove the rear screws [B] x2. Press the Reset Yellow key 3. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. Open and close the door two more times. To prevent toner leakage, never loosen or remove gestrtner screws gestetner dsm730 in the illustration gestetner dsm730. However when I attempt to send a fax from my PC I get the following error message: Therefore, I would recommend cleaning off a desk or work area ahead of time, organize your parts, then remove the PCU unit and take it over to the area where you will be working.

Related Drivers:  PCG-7112L DRIVER

Remove the bottom part [D]. Make sure that the holes for the screws on the front and rear end of the PCU gestetner dsm730 aligned correctly. Make 5 sample copies. Thank you for your timely replies. Remove the front cover [A] gestetner dsm730.